The Comparison of Tunnel Convergence from Numerical Analysis with Monitoring Data Based on Different Constitutive Models in Rock Medium

Document Type : Research Papers

Authors

1 Ph.D., Graduate Student, Department of Civil Engineering, Shiraz University, Shiraz, Iran.

2 Professor, Department of Civil and Environmental Engineering, Shiraz University, Shiraz, Iran.

Abstract

Tunnels are used for numerous purposes; therefore, proper evaluation and prediction of tunnel behavior, influenced by the surrounding environment's characteristics, is of great concern for civil engineers. In this regard, two water convey and railway tunnels in rock medium were modelled to investigate the influence of various constitutive models on tunnels’ behaviors prediction. The tunnel convergence predicted by each constitutive model was compared with the reported monitoring data. Then, the most appropriate constitutive models for tunnel analysis in each rock category were proposed according to the strength of each category’s rocks. The results indicated that the Mohr-Coulomb criteria for very weak rocks, the Generalized Hoek-Brown for weak rocks and the Generalized Hoek-Brown with the residual parameter criteria for modelling medium rocks, had more reliable predictions of tunnel convergence. Also, utilizing shear strength parameters correlated from rock mass specific parameters to analyze tunnels in weak and medium rocks was not satisfactory.

Keywords


Aksoy, C.O. and Uyar, G.G. (2017). "Non-deformable support system in swelling and squeezing rocks", In: Rock Mechanics and Engineering, Volume 4 (pp. 179-203), CRC Press.
Alejano, L.R. and Alonso, E. (2005). "Considerations of the dilatancy angle in rocks and rock masses", International Journal of Rock Mechanics and Mining Sciences, 42(4), 481-507, https://doi.org/10.1016/j.ijrmms.2005.01.003.
Asadollahpour, E. (2011). "An investigation into the behaviour of a tunnel in a viscoplastic medium case study: Babolak water conveyance tunnel", M.Sc. Thesis, Shahid Bahonar University of Kerman, Kerman, Iean.
Asadollahpour, E., Rahmannejad, R., Asghari, A. and Abdollahipour, A. (2014). "Back analysis of closure parameters of Panet equation and Burger׳s model of Babolak water tunnel conveyance", International Journal of Rock Mechanics and Mining Sciences, 68, 159-166, https://doi.org/10.1016/j.ijrmms.2014.02.017.
Beyabanaki, A.R. and Gall, V. (2017). "3D numerical parametric study of the influence of open-pit mining sequence on existing tunnels", International Journal of Mining Science and Technology, 27(3), 459-466, https://doi.org/10.1016/j.ijmst.2017.03.018.
Bieniawski, Z.T. (1993). "Classification of rock masses for engineering: The RMR system and future trends", In: Rock Testing and Site Characterization, (pp. 553-573), Pergamon, https://doi.org/10.1016/B978-0-08-042066-0.50028-8.
Chen, S.-L. and Lee, S.-C. (2020). "An investigation on tunnel deformation behavior of expressway tunnels", Geomechanics and Engineering, 21(2), 215-226, https://doi.org/10.12989/gae.2020.21.2.215.
Chen, Y. and Lin, H. (2019). "Consistency analysis of Hoek–Brown and equivalent Mohr–Coulomb parameters in calculating slope safety factor", Bulletin of Engineering Geology and the Environment, 78(6), 4349-4361, https://doi.org/10.1007/s10064-018-1418-z.
Dadashi, E., Ahangari, K., Noorzad, A. and Arab, A. (2012). "Support system suggestion based on back-analysis results case study: Babolak water conveyance tunnel", Arabian Journal of Geosciences, 5(6), 1297-1306.
Davis, R.O. and Selvadurai, A.P.S. (2005). Plasticity and geomechanics, Cambridge University Press.
Eberhardt, E. (2012). "The hoek–brown failure criterion", In: The ISRM Suggested Methods for Rock Characterization, Testing and Monitoring: 2007-2014, (pp. 233-240), Springer, Cham.
Fang, Y., Cui, J., Wanatowski, D., Nikitas, N., Yuan, R. and He, Y. (2022). "Subsurface settlements of shield tunneling predicted by 2D and 3D constitutive models considering non-coaxiality and soil anisotropy: A case study", Canadian Geotechnical Journal, 59(3), 424-440, https://doi.org/10.1139/cgj-2020-062.
Goel, R.K. and Singh, B. (2011). Engineering rock mass classification: Tunnelling, foundations and landslides, Elsevier.
Hajiazizi, M., Taban, M.H. and Ghobadian, R. (2021). "Prediction of Q-value by multi-variable regression and novel Genetic Algorithm based on the most influential parameters", Civil Engineering Infrastructures Journal, 54(2), 267-280, https://doi.org/10.22059/CEIJ.2020.295339.1647.
He, M., Zhang, Z., Zhu, J. and Li, N. (2022). "Correlation between the constant mi of Hoek–Brown criterion and porosity of intact rock", Rock Mechanics and Rock Engineering, 55(2), 923-936.
He, M., Zhang, Z., Zheng, J., Chen, F. and Li, N. (2020). "A new perspective on the constant mi of the Hoek–Brown failure criterion and a new model for determining the residual strength of rock", Rock Mechanics and Rock Engineering, 53(9), 3953-3967, https://doi.org/10.1007/s00603-020-02164-6.
Hejazi, Y., Dias, D. and Kastner, R. (2008). "Impact of constitutive models on the numerical analysis of underground constructions", Acta Geotechnica, 3(4), 251-258, https://doi.org/10.1007/s11440-008-0056-1.
Hoek, E., Carranza-Torres, C. and Corkum, B. (2002). "Hoek-Brown failure criterion-2002 edition", Proceedings of NARMS-Tac, 1(1), 267-273
Hoek, E. and Brown, E.T. (1997). "Practical estimates of rock mass strength", International Journal of Rock Mechanics and Mining Sciences, 34(8), 1165-1186, https://doi.org/10.1016/S1365-1609(97)80069-X.
Hoek, E. and Brown, E.T. (2019). The Hoek-Brown failure criterion and GSI-2018 edition", Journal of Rock Mechanics and Geotechnical Engineering, 11(3), 445-463, https://doi.org/10.1016/j.jrmge.2018.08.001.
Hoek, E., Kaiser, P.K. and Bawden, W.F. (2000). Support of underground excavations in hard rock, CRC Press.
Hoek, E., Wood, D. and Shah, S. (1992). Support of underground excavations in hard rock, A modified Hoek–Brown failure criterion for jointed rock masses", In: Rock Characterization: ISRM Symposium, Eurock'92, Chester, UK, 14-17 September, (pp. 209-214), Thomas Telford Publishing.
Jallow, A., Ou, C.Y. and Lim, A. (2019). "Three-dimensional numerical study of long-term settlement induced in shield tunneling", Tunnelling and Underground Space Technology, 88, 221-236, https://doi.org/10.1016/j.tust.2019.02.021.
Jin, Y.F., Zhu, B.Q., Yin, Z.Y. and Zhang, D.M. (2019). "Three-dimensional numerical analysis of the interaction of two crossing tunnels in soft clay", Underground Space, 4(4), 310-327, https://doi.org/10.1016/j.undsp.2019.04.002.
Li, C., Hou, S., Liu, Y., Qin, P., Jin, F. and Yang, Q. (2020). "Analysis on the crown convergence deformation of surrounding rock for double-shield TBM tunnel based on advance borehole monitoring and inversion analysis", Tunnelling and Underground Space Technology, 103, 103513, https://doi.org/10.1016/j.tust.2020.103513.
MIDAS Information Technology Co. (2018). Chapter 4: Mesh, In: Midas GTS NX User Manual, (pp. 145-146).
Möller, S.C. and Vermeer, P.A. (2008). "On numerical simulation of tunnel installation", Tunnelling and Underground Space Technology, 23(4), 461-475, https://doi.org/10.1016/j.tust.2007.08.004.
Mousivand, M. and Maleki, M. (2018). "Constitutive models anddetermining methods effects on application of convergence-confinement method in underground excavation", Geotechnical and Geological Engineering, 36(3), 1707-1722, https://doi.org/10.1007/s10706-017-0426-2.
Ng, C.W.W., Sun, H.S., Lei, G.H., Shi, J.W. and Mašín, D. (2015). "Ability of three different soil constitutive models to predict a tunnel’s response to basement excavation", Canadian Geotechnical Journal, 52(11), 1685-1698, https://doi.org/10.1139/cgj-2014-0361.
Oettl, G., Stark, R.F. and Hofstetter, G. (1998). "A comparison of elastic-plastic soil models for 2D FE analyses of tunnelling", Computers and Geotechnics, 23(1-2), 19-38, https://doi.org/10.1016/S0266-352X(98)00015-9.
Rocdata Software Manual. (2004). R.I.R. Version 3.0 User’s Guide of RocData: Strength analysis of rock and soil masses using the generalized Hoek–Brown, Mohr–Coulomb, Barton–Bandis and power curve failure critera”, Toronto, Ontario, Canada, (n.d.).
Rukhaiyar, S. and Samadhiya, N.K. (2016). "Analysis of tunnel considering Modified Mohr-Coulomb criteria", Recent Advances in Rock Engineering (RARE 2016), Atlantis Press.
Sarikhani Khorami, M. (2012). "Analysis of geomechanical parameters and in situ stress of rock mass in Isfahan-Shiraz railway tunnel using back analysis based on displacement monitoring", M.Sc. Thesis, Isfahan University of Technology, Isfahan, Iran.
Sharifzadeh, M., Daraei, R. and Broojerdi, M.S. (2012). "Design of sequential excavation tunneling in weak rocks through findings obtained from displacements based back analysis", Tunnelling and Underground Space Technology, 28, 10-17, https://doi.org/10.1016/j.tust.2011.08.003.
Singh, B. and Goel, R.K. (1999). Rock mass classification: A practical approach in civil engineering, (Vol. 46), Elsevier.
Su, K., Zhang, Y.-J., Chang, Z.-H., Wu, H.-G., Wang, T. and Zhou, W. (2019). "Transverse extent of numerical model for deep buried tunnel excavation", Tunnelling and Underground Space Technology, 84, 373-380, https://doi.org/10.1016/j.tust.2018.11.034.
Sulem, J., Panet, M, and Guenot, A. (1987). "Closure analysis in deep tunnels", International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts, 24(3), 145-154, https://doi.org/10.1016/0148-9062(87)90522-5.
Sun, H., Liu, S., Zhong, R. and Du, L. (2020). "Cross-section deformation analysis and visualization of shield tunnel based on mobile tunnel monitoring system", Sensors, 20(4), 1006, https://doi.org/10.3390/s20041006.
Vakili, K., Lavasan, A.A., Schanz, T. and Datcheva, M. (2014). "The influence of the soil constitutive model on the numerical assessment of mechanized tunneling", Proceedings of the 8th European Conference on Numerical Methods in Geotechnical Engineering, Delft, The Netherlands, 889-894.
Vitali, O.P.M., Celestino, T.B. and Bobet, A. (2018). "3D finite element modelling optimization for deep tunnels with material nonlinearity", Underground Space, 3(2), 125-139, https://doi.org/10.1016/j.undsp.2017.11.002.
Xing, Y., Kulatilake, P. and Sandbak, L.A. (2018). "Investigation of rock mass stability around the tunnels in an underground mine in USA using three-dimensional numerical modeling", Rock Mechanics and Rock Engineering, 51(2), 579-597, https://doi.org/10.1007/s00603-017-1336-6.
Xue, Y., Zhou, B., Li, S., Qiu, D., Zhang, K., and Gong, H. (2021). "Deformation rule and mechanical characteristic analysis of subsea tunnel crossing weathered trough", Tunnelling and Underground Space Technology, 114, 103989, https://doi.org/10.1016/j.tust.2021.103989.
Yasitli, N.E. (2016). "Comparison of input parameters regarding rock mass in analytical solution and numerical modelling", Journal of African Earth Sciences, 124, 497-504, https://doi.org/10.1016/j.jafrearsci.2016.08.010.
Zhao, C., Alimardani Lavasan, A., Barciaga, T., Kämper, C., Mark, P. and Schanz, T. (2017). "Prediction of tunnel lining forces and deformations using analytical and numerical solutions", Tunnelling and Underground Space Technology, 64, 164-176,  https://doi.org/10.1016/j.tust.2017.01.015.