Three-Dimensional Finite Element Modeling of Stone Column-Improved Soft Saturated Ground

Document Type : Research Papers

Authors

1 School of Civil Engineering, University of Tehran, Tehran, Iran

2 School of Civil Engineering, College of Engineering, University of Tehran, Tehran, Iran

3 School of Civil Engineering, Collage of Engineering, University of Tehran, Tehran, Iran

Abstract

Installing stone columns in the ground is an effective improvement technique to increase the load bearing capacity and reduce the consolidation settlement of the loose or weak cohesive soils. In addition to the increase in the bearing capacity and reduction in the settlement, stone columns can accelerate the dissipation rate of the excess pore water pressure generated by the surcharge, which expedites the ground improvement procedure. Due to these advantages, this technique has been widely used to improve the mechanical properties of the soft and problematic soils. In this study, the behavior of stone columns in saturated soft grounds are studied using Finite Element (FE) numerical method. For this purpose, a three-dimensional (3D) FE model of the stone column-improved ground is built considering the nonlinear behavior of the soil and stone columns. This model considers the effect of consolidation, and its accuracy is verified using the unit cell concept and the results of a real ground improvement project in Iran. In addition, a parametric study is performed using the verified FE model to investigate the effect of different material and geometric characteristics of the stone columns on the behavior of improved ground. At the end, the efficacy of the stone column method is compared to that of deep soil mixing (DSM) ground improvement technic.

Keywords

Main Subjects


Ambily, A.P. and Gandhi, S.R. (2007). “Behavior of stone columns based on experimental and FEM analysis”, Journal of Geotechnical and Geoenvironmental Engineering, 133(4), 405-415.
Balaam, N.P. and Booker, J.R. (1981). “Analysis of rigid rafts supported by granular piles”, International Journal for Numerical and Analytical Methods in Geomechanics, 5(4), 379-403.
Barksdale, R.D. and Bachus, R.C. (1983). “Design and construction of stone columns Volume I, Appendixes”, Washington, D.C., USA: Federal Highway Administration.
Barron, R.A. (1948). “Consolidation of fine-grained soils by drain wells”, Transactions ASCE, Vol. 113, Paper No. 2346.
Bruce, M.E.C., Berg, R.R., Collin, J.G., Filz, G.M., Terashi, M. and Yang, D.S. (2013). “Federal Highway Administration design manual: Deep mixing for embankment and foundation support”, Publication No. FHWA-HRT-13-046.
Castro, J. and Sagaseta, C. (2011). “Consolidation and deformation around stone columns: Numerical evaluation of analytical solutions”, Computers and Geotechnics, 38(3), 354-362.
Castro, J., Cimentada, A., da Costa, A., Cañizal, J. and Sagaseta, C. (2013). “Consolidation and deformation around stone columns: Comparison of theoretical and laboratory results”, Computers and Geotechnics, 49, 326-337.
Han, J. (2015). Principles and practice of ground improvement, John Wiley & Sons.
Han, J. and Ye, S.L. (2001). “Simplified method for consolidation rate of stone column reinforced foundations”, Journal of Geotechnical and Geoenvironmental Engineering, 127(7), 597-603.
Hibbitt, Karlsson and Sorensen. (2001). “ABAQUS/Explicit: User's manual (Vol. 1)”, Hibbitt, Karlsson and Sorenson.
Hughes, J.M.O. and Withers, N.J. (1974). “Reinforcing of soft cohesive soils with stone columns”, Ground Engineering, 7(3), 42-49.
Indraratna, B., Ngo, N.T., Rujikiatkamjorn, C. and Sloan, S.W. (2015). “Coupled Discrete Element–Finite Difference method for analysing the load-deformation behaviour of a single stone column in soft soil”, Computers and Geotechnics, 63, 267-278.
Moayedi, H., Huat, B.B., Mokhberi, M., Moghaddam, A.A. and Moghaddam, S.A. (2010). “Using stone column as a suitable liquefaction remediation in Persian Gulf coast”, Electronic Journal of Geotechnical Engineering, 15(P), 1757-1767.
Mousavi, S.E. and Wong, L.S. (2016). “Permeability characteristics of compacted and stabilized clay with cement, peat ash and silica sand”, Civil Engineering Infrastructures Journal, 49(1), 149-164.
Priebe, H.J. (1995). “The design of vibro replacement”, Ground Engineering, 28(10), 31.
Pulko, B., Majes, B. and Logar, J. (2011). “Geosynthetic-encased stone columns: Analytical calculation model”, Geotextiles and Geomembranes, 29(1), 29-39.
Reinforced Earth Iran Company, (2013), “Designing report for constructing the foundation of storage building of Khayyam steel mill project in Neyshabur, Iran”, http://khakemosalah.ir/content/573.
Saeedi Azizkandi, A. and Fakher, A. (2014). “A simple algorithm for analyzing a piled raft by considering stress distribution”, Civil Engineering Infrastructures Journal, 47(2), 215-227.
Tan, S.A., Ng, K.S. and Sun, J. (2014). “Column groups analyses for stone column reinforced foundation”, Geotechnical Special Publication, 233, 597-608.
Tan, S.A., Tjahyono, S. and Oo, K.K. (2008). “Simplified plane-strain modeling of stone-column reinforced ground”, Journal of Geotechnical and Geoenvironmental Engineering, 134(2), 185-194.